CDC STACKS serves as an archival repository of CDC-published products including scientific findings, journal articles, guidelines, recommendations, or other public health information authored or co-authored by CDC or funded partners.
As a repository, CDC STACKS retains documents in their original published format to ensure public access to scientific information.
i
Scrap Processor Struck by Wrench and Dies after Makeshift Torque System Fails
-
2015/03/05
[PDF-1.12 MB]
Details:
-
Corporate Authors:
-
Description:On June 30, 2014, a 42-year-old scrap processor was instructed by his supervisor to salvage the main bolts on a locomotive flywheel that was being scrapped, so the normal procedure of removing them with a torch was replaced by the following method: To increase tension, the scrap processor wrapped one end of a large 48 mm wrench with a makeshift sling that was tied at the other end to an excavator grapple. The scrap processor fit the wrench on the bolt and an excavator operator applied tension to the sling on the excavator. Once the bolt was loosened, the scrap processor signaled the excavator operator to lower the tension, after which the scrap processor moved the wrench to the next bolt. After successfully removing 40 bolts using this method, the scrap processor placed the wrench on the next bolt and signaled the excavator operator to apply tension. While tension was applied, the victim grabbed the sling and leaned over to observe the bolt. The wrench slipped off the bolt, shot out and struck the victim on the right side of his head causing him to fall 6 feet to the ground, striking several pieces of scrap metal. Emergency Medical Services were called at 11:40 am. They arrived approximately 15 minutes later and the victim was flown to a Level 4 trauma center. Physicians placed the victim into an induced coma. The victim succumbed to his injuries 13 days later and died. To prevent future occurrences of similar incidents, the following recommendations have been made: Recommendation No. 1: Employers should ensure employees use appropriate tools for the required job. Recommendation No. 2: Employers should ensure employees use appropriate personal protective equipment such as hard hats, and fall protection. Recommendation No 3: Employers should require guarding or ensure that fall protection is utilized when employees are working four feet or more above ground. Recommendation No 4: Employers should develop and implement a comprehensive safety and health program that includes an operating procedure for removing bolts on a locomotive flywheel.
-
Subjects:
-
Keywords:
-
FACE - NIOSH and State:
-
Series:
-
Subseries:
-
DOI:
-
Publisher:
-
Document Type:
-
Funding:
-
Genre:
-
Place as Subject:
-
CIO:
-
Topic:
-
Location:
-
Pages in Document:1-8
-
NIOSHTIC Number:20046508
-
NTIS Accession Number:PB2015-105624
-
Citation:Morgantown, WV: U.S. Department of Health and Human Services, Public Health Service, Centers for Disease Control and Prevention, National Institute for Occupational Safety and Health, FACE 14KY036, 2015 Mar; :1-8
-
Federal Fiscal Year:2015
-
Performing Organization:University of Kentucky
-
Peer Reviewed:False
-
NAICS and SIC Codes:
-
Start Date:2005/07/01
-
End Date:2026/06/30
-
Resource Number:FACE-14KY036
-
Collection(s):
-
Main Document Checksum:
-
Download URL:
-
File Type:
