Welcome to CDC stacks | Ti-6Al-4V Alloy Castings Prepared in Zircon Sand Molds and the Effect of Hot Isostatic Pressing; Bureau of Mines Report of Investigations -1984 RI 8897 - 10750 | National Institute for Occupational Safety and Health
Stacks Logo
Advanced Search
Select up to three search categories and corresponding keywords using the fields to the right. Refer to the Help section for more detailed instructions.
 
 
Help
Clear All Simple Search
Advanced Search
Ti-6Al-4V Alloy Castings Prepared in Zircon Sand Molds and the Effect of Hot Isostatic Pressing; Bureau of Mines Report of Investigations -1984 RI 8897
  • Published Date:
    1/1/1984
Filetype[PDF-8.45 MB]


This document cannot be previewed automatically as it exceeds 5 MB
Please click the thumbnail image to view the document.
Ti-6Al-4V Alloy Castings Prepared in Zircon Sand Molds and the Effect of Hot Isostatic Pressing; Bureau of Mines Report of Investigations -1984 RI 8897
Details:
  • Description:
    The Bureau of Mines conducted studies to provide data on the room temperature mechanical properties of Ti-6Al-4V alloy cast in waterglass-bonded zircon sand and to determine the effect of hot iso-static pressing (HIP) on these properties. Data on the cast and annealed Ti-6Al-4V alloy were compared with published data for forged and investment-cast Ti-6Al-4V alloy. The average Charpy V-notch impact strength compared favorably with the typical values of 17 ft•lbf for wrought material and 19.2 ft•lbf for investment-cast material. The room temperature mechanical proper-ties of cast and annealed material compared favorably with published values for investment-cast Ti-6Al-4V alloy and exceeded the specifications for (1) titanium and titanium alloy castings, grade C-5 according to ASTM B367-69, and (2) titanium alloy bars and forgings as specified in AMS4928H, except for the AMS4928H minimum requirement for reduction in area (25 pct). The minimum requirements are: tensile strength, 130 ksi; yield strength, 120 ksi (0.2 pct); and elongation, 6 pct. None of the specimens tested met the AMS4928H minimum requirement for reduction in area. The HIP process healed the internal casting porosity in the test specimens, but the fatigue strength was not significantly improved. The fatigue properties of both the cast and cast plus hot isostatically pressed castings were significantly lower than those of wrought products.

  • Supporting Files:
    No Additional Files
No Related Documents.
You May Also Like: