Advanced Search
Select up to three search categories and corresponding keywords using the fields to the right. Refer to the Help section for more detailed instructions.

Search our Collections & Repository

All these words:

For very narrow results

This exact word or phrase:

When looking for a specific result

Any of these words:

Best used for discovery & interchangable words

None of these words:

Recommended to be used in conjunction with other fields

Language:

Dates

Publication Date Range:

to

Document Data

Title:

Document Type:

Library

Collection:

Series:

People

Author:

Help
Clear All

Query Builder

Query box

Help
Clear All

For additional assistance using the Custom Query please check out our Help Page

i

Investigation Of Fully Grouted Roof Bolts Installed Under In Situ Conditions

  • 2005

  • Source: Proceedings of the 24th International Conference on Ground Control in Mining, August 2-4, 2005, Morgantown, West Virginia. Peng SS, Mark C, Tadolini SC, Finfinger GL, Khair AW, Heasley KA, eds. Morgantown, WV: West Virginia University, 2005 Aug; :302-31
Filetype[PDF-1.15 MB]


  • English
    • Details You May Also Like

    Details:

    • Personal Author:
    • Corporate Authors:
      Pittsburgh Research Laboratory (National Institute for Occupational Safety and Health)
    • Conference Authors:
      International Conference on Ground Control in Mining (24th : 2005August 2-4: Morgantown, WV)
    • Description:
      The The National Institute for Occupational Safety and Health (NIOSH) Pittsburgh Research Laboratory (PRL) is continuing to investigate the behavior of fully grouted roof bolts in the weak roof rock of the Safety Research Coal Mine (SRCM). This paper describes the results of three studies: • A series of 24 pull tests of bolts installed fully grouted and overcored to leave 12 inches of grouted bolt. The tests compared the pull-out performance of offset-head roof bolts with that of standard 5/8-inch bolts; • A second series of 24 tests that compared the pull-out loads obtained by bolts installed with 1 ft of resin (a Short Encapsulation Pull Test or SEPT) to that of fully grouted bolts overcored to leave only 12 inches of grouted bolt, and; • An investigation into the pressures generated during the installation of fully grouted resin bolts. All of the bolts installed and pulled were overcored and removed from the roof after the pull tests to allow inspection of the resin. The first study found that there was no significant difference in pullout load between the offset-head bolts and the standard bolts. The second study, comparing the SEPT bolts and the partially-overcored fully grouted bolts, indicated that SEPT can significantly underestimate bolt anchorage grip factor, suggesting that the SEPT is a conservative measure of actual bolt performance. Significant loss of resin to cracks in the roof was observed in the bolts overcored in the SRCM. The third study explored one possible explanation for the resin loss, high pressures generated during bolt installation. These tests employed bolts installed in strain gauged steel tubes. The results confirmed that significant pressures (greater than 4,000 psi) can be generated during bolt installation. The results of the pressure tests, combined with the observations of resin loss in bolts installed in the SRCM, suggest that under some circumstances resin loss and under-encapsulation could take place and lead to degraded bolt performance. Glove fingering was observed in all recovered bolts to various degrees. The limited comparative data suggested that the effect of glove fingering ranged from slight to moderate. Complete mixing of the resin was observed on all of the 40 bolts recovered (28 fully grouted and 12 SEPT). Australian and U.S. resins were compared and the Australian resins were observed to have much smaller catalyst compartment areas and lower resin viscosities. These differences are suggested as potential explanations for occasional resin mixing problems noted in Australian resin bolt installations.
    • Subjects:
    • Source:
      Proceedings of the 24th International Conference on Ground Control in Mining, August 2-4, 2005, Morgantown, West Virginia. Peng SS, Mark C, Tadolini SC, Finfinger GL, Khair AW, Heasley KA, eds. Morgantown, WV: West Virginia University, 2005 Aug; :302-31
    • Document Type:
      Book Chapter
    • Genre:
      Conference Publications
    • Collection(s):
    • Main Document Checksum:
    • Download URL:
    • File Type:

    Supporting Files

    • No Additional Files

    More +

    You May Also Like

    Checkout today's featured content at stacks.cdc.gov