Conducting prevalence surveys at 5- to 10-year intervals would allow countries to determine their case detection performance.
The World Health Organization's goal for tuberculosis (TB) control is to detect 70% of new, smear-positive TB cases and cure 85% of these cases. The case detection rate is the number of reported cases per 100,000 persons per year divided by the estimated incidence rate per 100,000 per year. TB incidence is uncertain and not measured but estimated; therefore, the case detection rate is uncertain. This article proposes a new indicator to assess case detection: the patient diagnostic rate. The patient diagnostic rate is the rate at which prevalent cases are detected by control programs and can be measured as the number of reported cases per 100,000 persons per year divided by the prevalence per 100,000. Prevalence can be measured directly through national prevalence surveys. Conducting prevalence surveys at 5- to 10-year intervals would allow countries with high rates of disease to determine their case detection performance by using the patient diagnostic rate and determine the effect of control measures.
Reversing global tuberculosis (TB) incidence by 2015 is included in the Millennium Development Goals (
WHO defines the cure rate as the proportion of new cases of smear-positive TB that were cured through treatment; this rate is routinely measured by treatment registers. The case detection rate is the proportion of incident smear-positive TB cases detected through a TB program. The case detection rate is measured as the notification rate of new cases of smear-positive TB divided by the estimated incidence rate.
Incidence is estimated by using various sources of information (
To measure the incidence of new cases of smear-positive TB directly, one would require at least two prevalence surveys, e.g., 1 year apart, as well as a surveillance mechanism to detect incident cases in patients dying or emigrating out between the first and second survey. Moreover, correct identification of persons with TB is needed to link results of the second survey to the first. If the time between surveys is reduced, this reduces the bias of patients dying or moving out, but the number of incident cases will be smaller, reducing precision. Direct measurement is thus costly and complicated, and no country is currently applying this method. As a result, the incidence of new cases of smear-positive TB is uncertain, and TB programs do not know whether they are reaching the case detection rate goal. This problem affects low-income countries with high rates of TB in particular, since these countries tend to have inadequate case detection and reporting systems.
These measurement problems are important because the effect of TB programs depends on their success in detecting cases. This article proposes an alternative indicator to measure TB case detection. This indicator does not directly measure the proportion of cases detected but the speed at which they are detected.
Since the case detection rate is estimated indirectly and is uncertain, another indicator that can be measured more directly would be desirable. This indicator is the rate at which prevalent case-patients are recruited by TB programs, referred to here as the patient diagnostic rate. In practice, this indicator can be measured as follows: the number of newly reported cases (i.e., never treated) of smear-positive TB per 100,000 population per year (notification rate) divided by the prevalence of new cases of smear-positive TB per 100,000 population. The numerator is obtained from surveillance data and the denominator from a prevalence survey. The denominator represents the population at risk for case detection, the numerator those actually detected. At present, the proposal is to restrict patient diagnostic rate to smear-positive cases because smear microscopy is currently the most widely applied tool to confirm TB in countries with high rates of disease. The proposal is restricted to new cases, since this best captures the effects of case detection. The prevalence of previously treated TB depends strongly on the cure rate. Patient diagnostic rates in countries conducting and reporting a prevalence survey during the past decade are presented in the Table.
A more refined estimate of patient diagnostic rate may be obtained by stratification for important variables that are recorded routinely, such as age, sex, urban versus rural areas, and DOTS versus non-DOTS areas. DOTS areas are defined as those that have adopted the WHO TB control strategy. Such stratification may help identify TB priorities for strengthening case finding and assess the effect of DOTS. In countries with a high prevalence of HIV infection, separate estimates for persons with and without HIV infection indicate differences in the patient diagnostic rate and death rates between TB patients with and without HIV co-infection (
The quantitative relationship between the case detection rate, patient diagnostic rate, and expected program effect depends on the way we conceive case detection. Two approaches have been used in the past, perhaps best explained with the models of Styblo (model 1) (
Model 1 assumes that cases are either detected after an average of 4 months or not at all (
How do these model targets compare with values of patient diagnostic rates we observe in the real world? A rough, indirect estimate of patient diagnostic rate in the Netherlands is 2.5 per person-year (Appendix). Of more relevance may be the direct estimates in countries with high rates of TB (
| Notification rate smear-+ TB per 100,000 | Prevalence rate smear-+ TB per 100,000 | PDR | Ref | |
|---|---|---|---|---|
| China, 2000 | 17 | 72 | 0.24 | |
| Philippines, 1997 | 118 | 229 | 0.51 | |
| Korea, 1995 | 26 | 60 | 0.43 |
aTB, tuberculosis; +, positive; PDR, patient diagnostic rate; ref, reference number. bIn the Philippines, total prevalence was 310/100,000. Of 50 cases with drug susceptibility results and known treatment history, 37 (74%) had not been previously treated. The assumption was that 74% of prevalent smear-positive patients had not been previously treated. In Korea, total prevalence was 93/100,000. The prevalence of new smear-positive TB was obtained from the unpublished survey report.
For the patient diagnostic rate to be a useful indicator, the best reporting rate should be obtained. For instance, if general hospitals in China, or the private sector in the Philippines and Korea, fail to notify the patients they treat, the patient diagnostic rate will be underestimated (the same limitation applies to the case detection rate). Therefore, the use of patient diagnostic rate is not an alternative to a good reporting system but supports the development of such a system. If the notification system detects most cases (e.g., with a patient diagnostic rate exceeding the goal of model 2 of 1.17), then reporting data may be used exclusively to monitor trends, as is done in countries with low rates of disease.
A limitation of the patient diagnostic rate is that measuring TB prevalence is complicated and costly with the current standard methods, which require the use of mobile chest radiograph equipment as a screening tool. However, this limitation can be overcome. High standard prevalence surveys have been shown to be feasible (
Nevertheless, new survey methods, using other diagnostic algorithms or new diagnostic methods, that do not require mobile chest radiographs would be beneficial. They would promote the measurement of TB case detection and program effect in the 22 countries with high rates of disease and in other high incidence-countries with limited resources, especially Africa.
The patient diagnostic rate is a measurable indicator for detecting patients with previously untreated cases of smear-positive TB. The expected effect of a TB control program on transmission increases with an increasing value of this indicator. A patient diagnostic rate of >0.84 would correspond to the original WHO goal proposed by Styblo of detecting >70% of incident cases. A patient diagnostic rate of >1.17 would meet the goal of 70% case detection as used by Dye et al. to project the effect of the DOTS strategy (
While monitoring performance is extremely useful in the short-term, monitoring effects, or at least the trend of TB prevalence, is most important in the medium- and long-term. Programs aimed at reducing TB prevelance can assess whether the decrease is occurring through reporting rates, if case detection is good, or by carrying out prevalence surveys every 5–10 years, if the completeness of case detection varies or is uncertain. Prevalence surveys would provide direct information on indicator 23 for measuring progress towards meeting the Millennium Development Goals (
Model 1, developed by Styblo (
Since the interest of this article is to assess case detection, the left part of
Where
Pnew = prevalence ratio of new (i.e., never treated) cases of smear-positive TB
Inew = incidence rate (
CDR= case detection rate = proportion of cases detected
By definition:
Where
Nnew = notification rate (
and thus
Model 2 was used by Dye et al. and assumes that incident cases are at risk for case detection and for death or self-cure (
Which is equivalent to:
Since PDR may be estimated as Nnew/Pnew this can also be presented as:
And since Nnew = CDR ∙ Inew:
To assess to what extent a constant rate of detection (assumed by model 2) is supported by data on delay before diagnosis, we used data from the Netherlands Tuberculosis Register. From 1996 to 2002, a total of 468 new cases of smear-positive TB were diagnosed among the Dutch; these cases were found through passive case finding and had a recorded delay in treatment. Person-weeks at risk for detection were estimated by week since onset and used as the denominator for the rate of detection. Patient diagnostic rate was first estimated ignoring death rates and self-cure, and then by assuming an average rate of death and self cure of 0.5
The relationship between case detection rate and patient diagnostic rate according to models 1 and 2 is presented in
However, the same case detection rate in models 1 and 2 represent different effects on TB prevalence. For instance, a case detection rate of 70% according to model 1 (which is the basis of the current WHO goal) corresponds with a reduction of the prevalence of new cases of smear-positive TB of 58%. According to model 2, to achieve a 58% reduction of this prevalence, a case detection rate of 58% is required (
In model 2, the patient diagnostic rate and the combined rate of death and self-cure were assumed to be constant, i.e., independent of time since diagnosis. The rate of detection based on reported patient's and doctor's delay in the Netherlands is presented in
I thank colleagues Frank Cobelens, Chris Dye, Paul Eilers, Peter Gondrie, Peter Small, Suzanne Verver, and Marieke van der Werf for critically reviewing an earlier version of this article.
Model 1, used by Styblo, of tuberculosis case detection and treatment outcome in tuberculosis control program. Prevalent cases are those within dotted line.
Models 1 and 2 on tuberculosis case detection. B) Model 2, used by Dye et al. with rate of case detection (PDR). B) the arrows depict rates; A) the arrows depict proportions of cases moving from one compartment to another.
Relationship of case detection rate (CDR) and patient diagnostic rate (PDR) according to model 1 and model 2.
Reduction of prevalence of new smear-positive tuberculosis depending on the case detection rate (CDR) according to model 1 and model 2.
Estimates of the patient diagnostic rate (PDR) in the Netherlands, depending on the duration of symptoms.
Dr. Borgdorff is professor of international health at the University of Amsterdam and head of the Research Unit of the KNCV Tuberculosis Foundation. His areas of interest include the molecular epidemiology of TB and other communicable diseases.