Welcome to CDC stacks |
Stacks Logo
Advanced Search
Select up to three search categories and corresponding keywords using the fields to the right. Refer to the Help section for more detailed instructions.
Clear All Simple Search
Advanced Search
Correlating abrasive wear to alloy additions in low-alloy steels
Filetype[PDF-7.04 MB]

This document cannot be previewed automatically as it exceeds 5 MB
Please click the thumbnail image to view the document.
Correlating abrasive wear to alloy additions in low-alloy steels
  • Description:
    "The Bureau of Mines studied the efect of alloy additions on abrasive wear of low-alloy steels. A dry-sand, rubber-wheel abrasion test apparatus using ASTM g65-81 procedure b was used for the abrasive wear tests. Eighty-six material heat-treatment combinations were abrasion tested. Results of these tests were analyzed statistically using regression analysis to see if additions of cr, mn, mo, ni, si, al, cu, and s were significant in affecting the abrasive wear rate of low-alloy steels. Regression analysis was also used to confirm hardness and c affect on the abrasive wear rate of these steels. It was found that for all the steels taken as a group, increased amounts of mn significantly reduced the wear rate, while increased amounts of mo and si increased the wear rate. Analysis also confirmed previous research done by others, that increasing hardness and amounts of c reduced the wear rate. For the hardened steels taken as a class, only increasing amounts of c and mn reduced the wear rate, while increases in si increased the wear rate. In the class of unhardened steels, increases in c, mn, and s reduced the wear rate, whereas increases in mo increased the wear rate. The steels with the best resistance to wear were two hardened experimental steels similar to aisi 1055 and aisi 1078." - NIOSHTIC-2 NIOSHTIC no. 10005359
  • Document Type:
  • Main Document Checksum:
  • Supporting Files:
    No Additional Files
No Related Documents.
You May Also Like: